Track belts
Made of rubber
The rubber we use is made up of several components that allow us to adjust its hardness exactly as we need it.
Since, the rubber we use has a much higher coefficient of friction, so the tractor's pulling force is increased compared to the original tracks as well.
No elongation
Since a belt made only of rubber would stretch in length when tension is applied, our belt is reinforced with fiberglass. The fibres are placed in the middle of the belt thickness, thus allowing the belt to bend.
Simple outside, complex inside.
At first look, the belt is just rubber, but there are actually more than 40 load-spreading pads and several metres of fibreglass reinforcement inside.
Bruder compatible
Our tracks are fully interchangeable with the tracks that come with the John Deere 9620RX tractor from Bruder.
Spread pads
These pads are used for many purposes. But most importantly, together with other elements, they ensure optimal belt behaviour.The pads are essential for the following three reasons:
-
1. Enhanced durability
To increase the life of the belt, the elements that transmit the torque from the drive wheel to the belt movement are reinforced with plastic spread pads.
-
2. Shape stability
Spread plastic pads not only make the entire element more rigid, but also help to spread the load over the entire width of the belt.
-
3. Noise reduction
Since the pads are fully rubber coated, so there is no annoying clicking that can occur when using the original belts.
Photos
These are pictures of the resulting belts. You can see its mounting on the vehicle, the internal cross section and a comparison with the original belt.
Choose your belt
Choose the belt or set that fits your needs.
